Table of Contents
Advertisement
h. Use the Inspect Mode key to look at the displays of the ringing line on the digital phones.
Depending on the number of ports, the call may be ringing on one or both of the digital sets.
The second line of the display should contain this information:
a
If the display does not contain this information, determine the cause and correct the problem
before continuing.
i.
Hang up phone A and phone C.
Internal Call Forwarded on Send All Calls to Coverage
j.
Set phone C to send all calls to coverage.
k. Using phone A, call phone C. Use the Inspect Mode key to look at the displays of the ringing
line on the digital phones. Depending on the number of ports, the call may be ringing on one or
both of the digital sets. The second line of the display should contain this information:
a = Test A EXT−A to Test C EXT−C
If the display does not contain this information, determine the cause and correct the problem
before continuing.
l.
Hang up phone A and cancel the SEND ALL CALLS feature on phone C.
Internal Call Forwarded on Forward All Calls
m. Set phone C to forward all calls to the Octel 200/300 hunt group.
n. Using phone A, call phone C. Use the Inspect Mode key to look at the displays of the ringing
line on the digital phones. Depending on the number of ports, the call may be ringing on one or
both of the digital sets. The second line of the display should contain this information:
a = Test A EXT−A to Test C EXT−C
If the display does not contain this information, determine the cause and correct the problem
before continuing.
o. Hang up phone A and cancel forwarding on phone C.
11. CALLS TO THE INTERCEPT EXTENSION (ATTENDANT) (New installation only)
This test verifies that each Octel 200/300 port extension can transfer a call to the intercept
extension (attendant).
a.
Connect the analog adapter to the 25-pair cable associated with slot 1.
b. Connect phone B to the jack position of the modular adapter that is associated with port1 of the
Octel 200/300.
c.
From phone A, call the extension number of phone B.
d. Answer phone B, perform a hookswitch flash, and press
number). Hang up phone B. Does phone A get connected to the attendant?
NO '
e.
Connect phone B to the jack position of the modular adapter of the next Octel 200/300 port
extension. Repeat steps b. through d. until every Octel 200/300 port has successfully transferred
a call to the attendant.
The System 85 testing is now complete. Proceed with installation of the ATTIC board.
PB60019-01
= Test A EXT−A to Test C EXT−C
Determine the cause and correct the problem before continuing.
AT&T System 85/Definity G2 Adaptive Integration
(or the attendant's extension
0
7.3-33
d
s
f
Octel 200/300
S.4.1
Advertisement
Chapters
Table of Contents
