Table of Contents
Advertisement
12.3-16
Integration Volume
Preparing the Octel 200/300
Before configuring the Octel 200/300 for adaptive integration, complete the following:
1.
2.
3.
4.
5.
Configuring Adaptive Integration on the Octel 200/300
To configure the Octel 200/300Adaptive Integration to work with System 85, changes to the COS,
INFORMATION Table, System Parameter Table and SLOTS Table must be made in UPDATE.
The following explains the type of changes that may be required.
.
Refer to the Octel 200/300 Configuration Checklist section for the configuration steps and
commands.
Mailbox COS
Caution!
Octel 200/300
S.4.1
List the database. Highlight areas where changes are
required.
Make note of the following for each port:
Number of the ports in the system
-
Port extension number
-
Integrated (Y/N)
-
Obtain Trunk Access Code (TAC) numbers from AT&T
vendor. If different company greetings will be used, enter
the Trunk Access Code for each route into the TRUNK
GROUP Table.
Set the number of ring cycles before forwarding for all
mailboxes that are forwarded to the Octel 200/300 to be one
less than the number of ring cycles in the System 85.
Proceed with configuring adaptive integration on the Octel
200/300.
COS Attribute 9 — LAMP OR DISPLAY PHONE MESSAGE
WAITING
For message waiting indication only, assign a COS with Attribute 9 to
those mailboxes that correspond to extensions that should have message
waiting indication.
Mailbox and extension numbers must match for
message waiting indication to operate correctly.
Command
n
.L ALL
____
.L SLOT
____
.A TRUNK
____
____
.M INFO
Index #7
.A SLOT
PB60019-01
Advertisement
Chapters
Table of Contents
