Avaya Octel 200 Installation And Maintenance Manual page 627

11.4 OCTEL 200/300 CONFIGURATION
This section describes the changes that must be made to the Octel 200/300 configuration for message
waiting indication and called party identification.
Changes for Message Waiting Indication
To configure the Octel 200/300 with message waiting indication on an M1, the following configuration
changes must be made through the UPDATE program.
Mailbox COS
System Parameters
SLOTS Table
Changes for Called Party Identification
To configure the Octel 200/300 with called party identification on an M1, the following configuration
changes must be made through the UPDATE program.
.
Mailbox and extension numbers should match for CPI to operate correctly. However, if digit
translation is used, matching mailbox and extension numbers are not required.
Mailbox COS
SLOTS Table
PB60019-01
COS Attribute 9 — LAMP OR DISPLAY PHONE MESSAGE
WAITING
Assign COS Attribute 9 to those mailboxes that should have message
waiting indication (lamp or stutter dial tone).
System Parameter 116 — SHOULD INTEGRATION BE
ACTIVATED?
Modify the value of System Parameter 116 to be YES.
For SIC8 integration, each link is configured for call processing/or
message waiting.
.
For optimal performance, it is recommended that links not be
configured to perform both call processing and message waiting.
Refer to the Configuration volume, Slots Table chapter, for further
information on configuring the SLOTS Table.
Attribute 15 — TRANSFER TO A RINGING EXTENSION
Assign a COS with Attribute 15 — TRANSFER TO A RINGING
EXTENSION, to mailboxes that are PBX forwarded to Octel 200/300.
The SLOTS Table is used to configure both Line Interface Cards (LICs)
and Integration Cards.
With M1 Adaptive Integration, all ports can be configured for AX
answering mode to maximize utilization of the Octel 200/300 ports.
Refer to the Configuration volume, Slots Table chapter, for further
information on configuring the SLOTS Table.
Meridian 1 Adaptive Integration
Octel 200/300
11-15
S.4.1