Avaya Octel 200 Installation And Maintenance Manual page 567

TRUNK GROUP Table
Changes for Message Waiting Indication
Using the SX-2000's message waiting indication control codes, the Octel 200/300 can provide Message
Waiting Indication for phones equipped with message waiting indicators. Phones without message
waiting indicators can be notified of messages with a special message waiting tone that the station owner
hears upon going off-hook.
If the SX-2000 has the class of service option COV Voice Mail Port this option can be assigned to all of
the Octel 200/300 ports so that any port can control message waiting indicators. If this class of service
option is not available or cannot be used, one or more Octel 200/300 ports must be dedicated for message
waiting control and cannot answer calls.
To enable the Octel 200/300 to control message waiting indicators, make the following configuration
changes using the UPDATE program.
Mailbox COS
SLOTS Table
PB60019-01
The TRUNK GROUP table specifies call processing parameters for
different trunk groups by the Octel 200/300 COS.
Configure Trunk Group 0 with a greeting for use with internal
forwarded calls received without extension numbers. The greeting
should specify that the person does not have a mailbox on the system.
COS Attribute 9 — LAMP OR DISPLAY PHONE MESSAGE
WAITING
Assign a COS with Attribute 9 to those mailboxes of extensions that are
to have Message Waiting Indication.
CONFIGURATION OF MESSAGE WAITING CONTROL PORT
For Mitel SX-2000 systems not using COV Voice Mail Port class of
service option, one or more ports must be dedicated to controlling
message waiting indicators.
If only one port is required for MWI, use System Parameter 106 to
specify the port. Set outcall to NO for this port. This port must not
receive calls and need not be a MIC port.
If multiple dedicated ports are required for MWI (e.g. if multiple MWI
ports are required but the COV Voice Mail Port option is not available
or if MWI ports are to be assigned by the Octel 200/300 Class of
Service), these ports must be MIC ports. Configure these ports as MIC
message waiting links in the SLOTS Table and set outcall to NO for
these ports. These ports must not receive calls.
Mitel SX-2000 Adaptive Integration
Octel 200/300
10.3-23
S.4.1