Northern Telecom Configuration Checklist
The steps to the Northern Telecom configuration are listed below. When the step is complete, put a check
in the check (n) column.
1.
2.
PB60019-01
For incoming trunks that autoterminate at the Octel 200/300,
a.
Review a hardcopy printout of the Route Datablock, to
determine the trunk access code numbers and list individual
trunk members to autoterminate.
b. If new trunk groups are to be answered by the Octel 200/300 and
are not programmed to autoterminate, do that now.
Answer YES to the autoprompt of the route Data Block
-
(RDB)
Enter the number of the hunt group to the ATDN prompt of
-
the Trunk Data Block. (This must be defined for each
individual member.)
Change the Customer Data Block. Activate the following
features:
Include display allowed (IDP)
-
(OPT command)
Message center allowed (MCI)
-
(OPT command)
Forward RNA non-DID calls
-
(FNAD command) optional by customer
Forward DID calls
-
(FNAD command) optional by customer
System Ring Cycle, Regular
-
(CFNA command) optional by customer
System Ring Cycle, Distinctive
-
(DFNA command) optional by customer
Northern Telecom Adaptive Integration with NPIC
13-13
n
Octel 200/300
S.4.1