Table of Contents
Advertisement
6. Use the Courtesy Up command to initialize the integration card. At the @ prompt enter
CU x y
x = slot number; y = unit number
If there are two units, both units would have to be initialized.
Repeat this step for unit 2.
7. Test the system for proper operation.
Once the down LED is OFF, the good LED is ON (green), and the yellow LEDs are ON, the card and
links are working properly.
Testing Adaptive Integration Features
This section describes the procedures for testing Adaptive Integration features. Once the MIC board is
installed and operational and the PBX cables are connected to the correct slots, continue with the
procedures listed below.
1. TESTING THE OCTEL 200/300 PORTS
This test verifies that all PBX Octel 200/300 port extensions are connected to the correct Octel
200/300 ports.
a.
On the Octel 200/300 terminal, enter
L T
and select
1. ALL ACTIVITIES.
and C for continuous display.
b. From phone A, call the extension of the Octel 200/300 port 1. Does the Octel 200/300 answer
with "To enter your mailbox, press pound"?
NO
If the system activity trace does not show that the correct port answered, change the port
connections to correct the problem.
c.
Repeat step b. for each of the MIC ports.
2. CONFIGURING THE OCTEL 200/300 FOR TEST
Before proceeding, make the following changes to the Octel 200/300 configuration. These
changes are temporary; they are required only for testing.
a.
Add an Octel 200/300 mailbox that has a mailbox number matching the extension number for
phone B. This mailbox is referred to as mailbox B.
b. Assign these attributes to the COS for mailbox B:
Attribute 9
Attribute 15 — TRANSFER TO RINGING
PB60019-01
Correct the problem before continuing.
'
— MESSAGE WAITING LAMP (message waiting indication only)
Mitel SX-200 Digital Adaptive Integration
Octel 200/300
10.1-33
S.4.1
Advertisement
Chapters
Table of Contents
