Timer Retry - H3C S3600 Series Command Manual

Command Manual – Multicast
H3C S3600 Series Ethernet Switches-Release 1510
In the case that none of the peers use the rp-policy keyword: According to the
configuration sequence, only the first static RPF peer whose connection state is
UP is active. All the SA messages from this peer will be received and those from
other static RPF peers will be discarded. Once the active static RPF peer fails
(because the configuration is removed or the connection is terminated), based on
the configuration sequence, the subsequent first static RPF peer whose
connection is in the UP state will be selected as the active static RPF peer.
Related command: peer, ip ip-prefix.
Example
# Configure a static RPF peer.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] ip ip-prefix list1 permit 130.10.0.0 16 greater-equal 16 less-equal 32
[H3C] msdp
[H3C-msdp] peer 130.10.7.6 connect-interface Vlan-interface 100
[H3C-msdp] static-rpf-peer 130.10.7.6 rp-policy list1

7.1.24 timer retry

Syntax
timer retry seconds
undo timer retry
View
MSDP view
Parameter
seconds: Connection request retry interval in seconds, ranging from 1 to 60.
Description
Use the timer retry command to configure a connection request retry interval.
Use the undo timer retry command to restore the default value.
By default, the connection request retry interval is 30 seconds.
Related command: peer.
Example
# Set the connection request retry interval to 60 seconds.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] msdp
Chapter 7 MSDP Configuration Commands
7-20