Mld Snooping Configuration Examples; Ipv6 Group Policy And Simulated Joining Configuration Example - H3C S3100 Series Operation Manual

Clear the statistics information of all kinds
of MLD messages learned by MLD
snooping
The reset mld-snooping group command works only on an MLD snooping–enabled VLAN.
The reset mld-snooping group command cannot clear the MLD snooping multicast group
information for static joining.

MLD Snooping Configuration Examples

IPv6 Group Policy and Simulated Joining Configuration Example

Network requirements
As shown in
to Switch A through Ethernet 1/0/1. Router A is the MLD querier on the subnet.
MLDv1 is required on Router A, MLD snooping version 1 is required on Switch A, and Router A will
act as the MLD querier on the subnet.
It is required that the receivers, Host A and Host B, attached to Switch A can receive IPv6 multicast
traffic addressed to IPv6 multicast group FF1E::101 only.
It is required that IPv6 multicast data for group FF1E::101 can be forwarded through Ethernet 1/0/3
and Ethernet 1/0/4 of Switch A even if Host A and Host B accidentally, temporarily stop receiving
IPv6 multicast data.
Figure 3-4 Network diagram for IPv6 group policy simulated joining configuration
Configuration procedure
1) Enable IPv6 forwarding and configure IPv6 addresses
To do...
Figure 3-4, Router A connects to the IPv6 multicast source through Ethernet 1/0/2 and
Use the command...
reset mld-snooping statistics
3-20
Remarks
Available in user view