Controlled-Interface-Type - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

controlled-interface-type

Syntax
Release Information
Description
Options
Mode
Related Topics
Copyright © 2010, Juniper Networks, Inc.
controlled-interface-type { controlledInterfaceType | set | superset }
no controlled-interface-type { controlledInterfaceType | all }
Command introduced in JunosE Release 7.1.0.
set and superset keywords added in JunosE Release 9.2.0.
Assigns controlled-interface types to a QoS parameter definition. Controlled-interface
types specify the types of logical interfaces whose queues and nodes can be controlled
by instances of the parameter definition. You can specify up to four controlled-interface
types for each parameter definition. The no version removes the controlled-interface
type from the parameter definition.
controlledInterfaceType—One of the following controlled-interface types: atm, atm-vc,
atm-vp, bridge, ethernet, fr-vc, ip, ip-tunnel, ipv6, l2tp-session, l2tp-tunnel, lsp, serial,
svlan, server-port, vlan
set—Specifies an interface set as a controlled-interface type
superset—Specifies an interface superset as a controlled-interface type
all—Removes all controlled-interface types
QoS Parameter Definition
Configuring a Basic Parameter Definition for QoS Administrators
Creating a QoS Parameter on an Interface Superset or Interface Set
Chapter 4: C Commands
455