Garp Timer Hold - H3C MSR Series Command Reference Manual

garp timer hold

Use garp timer hold to set the GARP Hold timer for an Ethernet port, Layer-2 aggregate interface,
or all ports in a port group.
Use undo garp timer hold to restore the default of the GARP Hold timer. This might fail if the default
is beyond the valid value range for the Hold timer.
Syntax
garp timer hold timer-value
undo garp timer hold
Default
The Hold timer is 10 centiseconds.
Views
Ethernet interface view, Layer-2 aggregate interface view, port group view
Default command level
2: System level
Parameters
timer-value: Specifies the Hold timer (in centiseconds), which must be a multiple of 5 and range from
10 (inclusive) to half the Join timer (inclusive).
Usage guidelines
The following matrix shows the command and hardware compatibility:
Hardware
MSR800
MSR 900
MSR900-E
MSR 930
MSR 20-1X
MSR 20
MSR 30
MSR 50
MSR 2600
MSR3600-51F
Examples
# Set the GARP Hold timer to 15 centiseconds, assuming that the Join timer is 30 centiseconds.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] garp timer hold 15
Related commands
•
display garp timer
•
garp timer join
Command compatibility
No
No
No
No
No
No
Yes
Yes
Yes
Yes
121