Switch Console - H3C MSR Series Probe Command Reference

Predefined user roles
network-admin
network-operator
Parameters
slot-num: Specifies a slot number. It must be 0 for an MSR 2600 or MSR 3600, and must be in the range
of 0 to 2 for an MSR 5600.
acc-addr: Specifies the hardware space in the range of 0 to 0xFFFFFFFFFFFFFFFF.
width-num: Specifies the PCI configuration access bit width in bytes. Valid values include 1, 2, 4, and 8.
Usage guidelines
This command reads the contents in the specified address space. The address space cannot be the IO
mapping space and must be able to be accessed directly. Examples of supported address spaces
include:
Memory address space.
•
Address spaces of CPUs' internal registers.
•
• Memory and IO space of a PCI device.
Address space of a local bus management device, such as the address space of a CPLD or RTC. The
•
flash memory is not included.
The supported spaces depend on the MPU model.

switch console

Use switch console on an MSR 5600 to change the operating mode of the MPU's console port.
Syntax
switch console { mpu | spu }
Views
Probe view
Predefined user roles
network-admin
network-operator
Parameters
mpu: Uses the MPU's console port for the MPU.
spu: Uses the MPU's console port for the SPU.
Usage guidelines
The MSR 5600 SPU card does not have console ports. To test or debug an SPU card, you can configure
the switch console spu command to use the MPU's console port.
20