Port Switch-Over; Sme Enable - H3C S7500E Series Command Reference Manual

Default Level
2: System level
Parameters
None
Description
Use the port link-type hybrid command to configure the OLT port as a hybrid port.
By default, any OLT port is an hybrid port.
Related commands: port hybrid vlan, port hybrid pvid vlan.
Examples
# Configure OLT 3/0/1 as a hybrid port.
<Sysname> system-view
[Sysname] interface olt 3/0/1
[Sysname-Olt3/0/1] port link-type hybrid

port switch-over

Syntax
port switch-over
View
Fiber backup group view
Default Level
2: System level
Parameters
None
Description
Use the port switch-over command to perform a master/slave switchover between the two OLT ports
in the fiber backup group.
After this command is executed, the original master OLT port becomes the new slave, while the
original slave OLT port becomes the new master.
Note that the slave OLT must be in the ready state for a switchover to happen.
Related commands: display fiber-backup group.
Examples
# Perform a manual master/slave switchover between the two OLT ports in fiber backup group 1.
<Sysname> system-view
[Sysname] ftth
[Sysname-ftth] fiber-backup group 1
[Sysname-fiber-group1] port switch-over

sme enable

Syntax
sme enable
undo sme enable
2-27