Siemens SINAMICS G120D List Manual page 8

Parameters
Overview of parameters
1.1 Overview of parameters
1.1.1 Explanation of the parameter list
Basic structure of parameter descriptions
The data in the following example has been chosen at random. The table below
contains all the information that can be included in a parameter description. Some
of the information is optional.
The parameter list (See Chapter 1.2) is structured as follows:
- - - - - - - - - - - - - - - - - - - - Start of example - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
pxxxx[0...n] BICO: Long parameter name / short parameter name
CU/PM variants Access level: 3
Can be changed: C(x), U, T
Unit group: 6_2
Min
0.00 [Nm]
Description: Text
Values: 0:
1:
2:
etc.
Recommenda- Text
tion:
Index: [0] = Name and meaning of index 0
[1] = Name and meaning of index 1
[2] = Name and meaning of index 2
etc.
Bit array: Bit Signal name
00 Name and meaning of bit 0
01 Name and meaning of bit 1
02 Name and meaning of bit 2
etc.
Dependency: Text
See also: pxxxx, rxxxx
See also: Fxxxxx, Axxxxx
Danger: Warning:
Caution: Notice:
Note: Information which might be useful.
- - - - - - - - - - - - - - - - - - - - End of example - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
The individual pieces of information are described in detail below.
1-8
Name and meaning of value 0
Name and meaning of value 1
Name and meaning of value 2
Caution:
Calculated: p0340 = 1
Scaling: p2002
Unit selection: p0505
Max
10.00 [Nm]
1 signal
Yes
Yes
Yes
Safety notices with a warning triangle
Safety notices without a warning triangle
© Siemens AG 2012 - 2013 All Rights Reserved
SINAMICS G120D List Manual (LH14), 01/2013
Data type: FloatingPoint32
Dyn. index: CDS, p0170
Function diagram: 8070
Factory setting
0.00 [Nm]
0 signal FP
No 8060
No -
No 8052