Siemens SINAMICS G120D List Manual page 11

CU/PM variants
Indicates for which Control Units (CU) and/or Power Modules (PM) the parameter
is valid. If no CU or PM is listed, then the parameter is valid for all variants.
The following information relating to "CU" and "PM" can be displayed under the
parameter number:
Table 1-1
CU/PM variants
CU240D-2_DP
CU240D-2_DP_F
CU240D-2_PN
CU240D-2_PN_F
CU250D-2_DP
CU250D-2_DP_F
CU250D-2_PN
CU250D-2_PN_F
Access level
Specifies the minimum access level required to be able to display and change the
relevant parameter. The required access level can be set using p0003.
The system uses the following access levels:
• 1: Standard (not adjustable, included in p0003 = 3)
• 2: Extended (not adjustable, included in p0003 = 3)
• 3: Expert
• 4: Service
Parameters with this access level are password protected.
Note:
Parameter p0003 is CU-specific (available on the Control Unit).
A higher access level will also include the functions of the lower levels.
© Siemens AG 2012 - 2013 All Rights Reserved
SINAMICS G120D List Manual (LH14), 01/2013
Information in the "CU/PM variants" field
All Control Units have this parameter.
CU240D-2 with PROFIBUS interface
CU240D-2 with PROFIBUS interface and PROFIsafe
CU240D-2 with PROFINET interface
CU240D-2 with PROFINET interface and PROFIsafe
CU250D-2 with PROFIBUS interface
CU250D-2 with PROFIBUS interface and PROFIsafe
CU250D-2 with PROFINET interface
CU250D-2 with PROFINET interface and PROFIsafe
Overview of parameters
Significance
Parameters
1-11