Siemens SINAMICS G120D List Manual page 380

Parameters
List of parameters
r3974 Drive unit status word / Drv_unit ZSW
Access level: 1
Can be changed: -
Units group: -
Min
-
Description: Displays the status word for the drive unit.
Bit field: Bit Signal name
00 Software reset active
01 Writing of parameters disabled as parame-
ter save in progress
02 Writing of parameters disabled as macro is
running
r3978 BICO CounterDevice / BICO CounterDevice
Access level: 4
Can be changed: -
Units group: -
Min
-
Description: Displays the counter reading for modified BICO interconnections on this device.
The counter is incremented by one for each modified BICO interconnection.
p3981 Faults acknowledge drive object / Faults ackn DO
Access level: 3
Can be changed: U, T
Units group: -
Min
0
Description: Setting to acknowledge all active faults of a drive object.
Notice: Safety messages cannot be acknowledged using this parameter.
Note: Parameter should be set from 0 to 1 to acknowledge.
After acknowledgement, the parameter is automatically reset to 0.
p3985 Master control mode selection / PcCtrl mode select
Access level: 3
Can be changed: U, T
Units group: -
Min
0
Description: Sets the mode to change over the master control / LOCAL mode.
Value: 0:
1:
Danger: When changing the master control in operation, the drive can manifest undesirable behavior - e.g. it can accelerate
up to another setpoint.
1-380
Change master control for STW1.0 = 0
Change master control in operation
Calculated: -
Scaling: -
Unit selection: -
Max
-
1 signal
Yes
Yes
Yes
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
1
Calculated: -
Scaling: -
Unit selection: -
Max
1
© Siemens AG 2012 - 2013 All Rights Reserved
SINAMICS G120D List Manual (LH14), 01/2013
Data type: Unsigned32
Dyn. index: -
Func. diagram: -
Factory setting
-
0 signal
No
No
No
Data type: Unsigned32
Dyn. index: -
Func. diagram: -
Factory setting
-
Data type: Unsigned8
Dyn. index: -
Func. diagram: 8060
Factory setting
0
Data type: Integer16
Dyn. index: -
Func. diagram: -
Factory setting
0
FP
-
-
-