Siemens SINAMICS G120D List Manual page 79

p0423[0...n] Absolute encoder rotary singleturn resolution / Enc abs singleturn
CU250D-2_DP_F Access level: 3
CU250D-2_PN_F
Can be changed: C(4)
Units group: -
Min
0
Description: Sets the number of measuring steps per revolution for a rotary absolute encoder. The resolution refers to the abso-
lute position.
Caution: This parameter is automatically pre-set for encoders from the encoder list (p0400). When selecting a catalog
encoder, this parameter cannot be changed (write protection). Information in p0400 should be carefully observed
when removing write protection.
p0425[0...n] Encoder rotary zero mark distance / Enc rot dist ZM
Access level: 3
Can be changed: C(4)
Units group: -
Min
0
Description: Sets the distance in pulses between two zero marks for a rotary encoder. This information is used for zero mark
monitoring.
Caution: This parameter is automatically pre-set for encoders from the encoder list (p0400). When selecting a catalog
encoder, this parameter cannot be changed (write protection). Information in p0400 should be carefully observed
when removing write protection.
Note: For distance-coded zero marks, this means the basic distance.
p0426[0...n] Encoder zero mark differential distance / Enc ZM Dif_dist
Access level: 3
Can be changed: C(4)
Units group: -
Min
1
Description: Sets the differential distance with distance-coded zero marks [signal periods].
The value corresponds to jump displacement of "zero mark with interference".
Caution: This parameter is automatically pre-set for encoders from the encoder list (p0400). When selecting a catalog
encoder, this parameter cannot be changed (write protection). Information in p0400 should be carefully observed
when removing write protection.
p0427[0...n] Encoder SSI baud rate / Enc SSI baud rate
CU250D-2_DP_F Access level: 3
CU250D-2_PN_F
Can be changed: C(4)
Units group: -
Min
0 [kHz]
Description: Sets the baud rate for an SSI encoder.
Notice: This parameter is automatically pre-set for encoders from the encoder list (p0400). When selecting a catalog
encoder, this parameter cannot be changed (write protection). Information in p0400 should be carefully observed
when removing write protection.
Note: SSI: Synchronous Serial Interface
© Siemens AG 2012 - 2013 All Rights Reserved
SINAMICS G120D List Manual (LH14), 01/2013
Calculated: -
Scaling: -
Unit selection: -
Max
1073741823
Calculated: -
Scaling: -
Unit selection: -
Max
16777215
Calculated: -
Scaling: -
Unit selection: -
Max
65535
Calculated: -
Scaling: -
Unit selection: -
Max
65535 [kHz]
Parameters
List of parameters
Data type: Unsigned32
Dyn. index: EDS, p0140
Func. diagram: 4704
Factory setting
8192
Data type: Unsigned32
Dyn. index: EDS, p0140
Func. diagram: 4704, 8570
Factory setting
2048
Data type: Unsigned16
Dyn. index: EDS, p0140
Func. diagram: -
Factory setting
1
Data type: FloatingPoint32
Dyn. index: EDS, p0140
Func. diagram: -
Factory setting
100 [kHz]
1-79