Siemens SINAMICS G120D List Manual page 443

r9794[0...19] SI crosswise comparison list (processor 1) / SI CDC_list P1
Access level: 3
Can be changed: -
Units group: -
Min
-
Description: Displays the numbers of the data items that are currently being compared crosswise on processor 1.
The content of the list of crosswise-compared data is dependent upon the particular application.
Note: Example:
r9794[0] = 1 (monitoring clock cycle)
r9794[1] = 2 (enable safety functions)
r9794[2] = 3 (F-DI changeover, tolerance time)
...
A complete list of numbers for crosswise-compared data items appears in fault F01611.
r9795 SI diagnostics STOP F (processor 1) / SI diag STOP F P1
Access level: 2
Can be changed: -
Units group: -
Min
-
Description: Displays the number of the cross-compared data item which caused STOP F on processor 1.
Dependency: Refer to: F01611
Note: A complete list of numbers for crosswise-compared data items appears in fault F01611.
r9798 SI actual checksum SI parameters (processor 1) / SI act chksm P1
Access level: 3
Can be changed: -
Units group: -
Min
-
Description: Displays the checksum for the Safety Integrated parameters checked using checksums on processor 1 (actual
checksum).
Dependency: Refer to: p9799, r9898
p9799 SI setpoint checksum SI parameters (processor 1) / SI setp_chksm P1
Access level: 3
Can be changed: C(95)
Units group: -
Min
0000 hex
Description: Sets the checksum for the Safety Integrated parameters checked using checksums on processor 1 (setpoint check-
sum).
Dependency: Refer to: r9798, p9899
© Siemens AG 2012 - 2013 All Rights Reserved
SINAMICS G120D List Manual (LH14), 01/2013
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
FFFF FFFF hex
Parameters
List of parameters
Data type: Unsigned16
Dyn. index: -
Func. diagram: 2802
Factory setting
-
Data type: Unsigned32
Dyn. index: -
Func. diagram: 2802
Factory setting
-
Data type: Unsigned32
Dyn. index: -
Func. diagram: 2800
Factory setting
-
Data type: Unsigned32
Dyn. index: -
Func. diagram: 2800
Factory setting
0000 hex
1-443