Siemens SINAMICS G120D List Manual page 570

Parameters
Quick commissioning (p0010 = 1)
Table 1-7
Par. no.
p1300
p1500
p1900
p1905
p2196
p3900
If p0010 = 1 is selected, p0003 (user access level) can be used to select the parameters that
are to be accessed.
At the end of the quick commissioning, set p3900 = 1 to perform the required motor calcula-
tions and reset all other parameters (not included in p0010 = 1) to their default settings.
Note:
This only applies for the quick commissioning.
1-570
Quick commissioning (p0010 = 1), continued
Name
Open-loop/closed-loop control operating mode
Torque setpoint selection
Motor data identification and rotating measurement 1
Parameter tuning selection
Torque utilization scaling
Completion of quick commissioning
Access level
2
2
1
1
1
© Siemens AG 2012 - 2013 All Rights Reserved
SINAMICS G120D List Manual (LH14), 01/2013
Change-
able
C(1)T
C(1)T
C(1)T
C(1)T
C(1,3)UT
C(1)