Siemens SINAMICS G120D List Manual page 484

Parameters
List of parameters
r20111 CO: MUL 0 product Y / MUL 0 product Y
CU240D-2_DP Access level: 3
CU240D-2_DP_F
Can be changed: -
CU240D-2_PN
Units group: -
CU240D-2_PN_F
Min
-
Description: Display parameter for the product Y = X0 * X1 * X2 * X3 of instance MUL 0 of the multiplier.
p20112 MUL 0 run-time group / MUL 0 RTG
CU240D-2_DP Access level: 3
CU240D-2_DP_F
Can be changed: T
CU240D-2_PN
Units group: -
CU240D-2_PN_F
Min
5
Description: Setting parameter for the run-time group in which instance MUL 0 of the multiplier is to be called.
Value: 5:
6:
9999: Do not calculate
p20113 MUL 0 run sequence / MUL 0 RunSeq
CU240D-2_DP Access level: 3
CU240D-2_DP_F
Can be changed: T
CU240D-2_PN
Units group: -
CU240D-2_PN_F
Min
0
Description: Setting parameter for the run sequence of instance MUL 0 within the run-time group set in p20112.
Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run
sequence value.
p20114[0...3] CI: MUL 1 inputs / MUL 1 inputs
CU240D-2_DP Access level: 3
CU240D-2_DP_F
Can be changed: T
CU240D-2_PN
Units group: -
CU240D-2_PN_F
Min
-
Description: Sets the signal source of the factors X0, X1, X2, X3 of instance MUL 1 of the multiplier.
Index: [0] = Factor X0
[1] = Factor X1
[2] = Factor X2
[3] = Factor X3
1-484
Run-time group 5
Run-time group 6
Calculated: -
Scaling: PERCENT
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
9999
Calculated: -
Scaling: -
Unit selection: -
Max
32000
Calculated: -
Scaling: PERCENT
Unit selection: -
Max
-
© Siemens AG 2012 - 2013 All Rights Reserved
SINAMICS G120D List Manual (LH14), 01/2013
Data type: FloatingPoint32
Dyn. index: -
Func. diagram: 7222
Factory setting
-
Data type: Integer16
Dyn. index: -
Func. diagram: 7222
Factory setting
9999
Data type: Unsigned16
Dyn. index: -
Func. diagram: 7222
Factory setting
270
Data type: U32 / FloatingPoint32
Dyn. index: -
Func. diagram: 7222
Factory setting
0