Siemens SINAMICS G120D List Manual page 16

Parameters
Overview of parameters
Table 1-5
Unit group
9_1
Function diagram
The parameter is included in this function diagram. The structure of the parameter
function and its relationship with other parameters is shown in the specified func-
tion diagram.
Parameter values
Min
Max
Factory setting
Description
Explanation of the function of a parameter
Values
Lists the possible values of a parameter.
Recommendation
Information about recommended settings.
1-16
Unit group (p0595)
Unit selection for p0595 =
Value
The values that can be set and the technological units are shown in
p0595 (See Chapter 1.2).
Minimum value of the parameter [unit]
Maximum value of the parameter [unit]
Value when shipped [unit]
In the case of a binector/connector input, the signal source
of the default BICO interconnection is specified. A non-
indexed connector output is assigned the index [0].
A different value may be displayed for certain parameters
(e.g. p1800) during first commissioning.
Reason:
The setting for these parameters is determined by the
operating environment of the Control Unit (e.g. by the device
type, or power unit).
Reference value
Unit
© Siemens AG 2012 - 2013 All Rights Reserved
SINAMICS G120D List Manual (LH14), 01/2013
for %