Siemens SINAMICS G120D List Manual page 297

Bit field: Bit Signal name
00 |n_act| < speed threshold value 3
01 f or n comparison value reached or
exceeded
04 Speed setp - act val deviation in tolerance
t_on
05 Ramp-up/ramp-down completed
11 Torque utilization < torque threshold value 2 Yes
Note: Re bit 00:
The speed threshold value 3 is set in p2161.
Re bit 01:
The comparison value is set in p2141. We recommend setting the hysteresis (p2142) for canceling the bit to a value
lower than that in p2141. Otherwise, the bit is not reset.
Re bit 11:
The torque threshold value 2 is set in p2194.
p2200[0...n] BI: Technology controller enable / Tec_ctrl enable
CU240D-2_DP Access level: 2
CU240D-2_DP_F
Can be changed: T
CU240D-2_PN
Units group: -
CU240D-2_PN_F
Min
-
Description: Sets the signal source to switch in/switch out the technology controller.
The technology controller is switched in with a 1 signal.
p2201[0...n] CO: Technology controller fixed value 1 / Tec_ctrl fix val1
CU240D-2_DP Access level: 2
CU240D-2_DP_F
Can be changed: U, T
CU240D-2_PN
Units group: 9_1
CU240D-2_PN_F
Min
-200.00 [%]
Description: Sets the value for fixed value 1 of the technology controller.
Dependency: Refer to: p2220, p2221, p2222, p2223, r2224, r2229
Notice: A BICO interconnection to a parameter that belongs to a drive data set always acts on the effective data set.
p2202[0...n] CO: Technology controller fixed value 2 / Tec_ctr fix val 2
CU240D-2_DP Access level: 2
CU240D-2_DP_F
Can be changed: U, T
CU240D-2_PN
Units group: 9_1
CU240D-2_PN_F
Min
-200.00 [%]
Description: Sets the value for fixed value 2 of the technology controller.
Dependency: Refer to: p2220, p2221, p2222, p2223, r2224, r2229
Notice: A BICO interconnection to a parameter that belongs to a drive data set always acts on the effective data set.
© Siemens AG 2012 - 2013 All Rights Reserved
SINAMICS G120D List Manual (LH14), 01/2013
1 signal
Yes
Yes
Yes
Yes
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: PERCENT
Unit selection: p0595
Max
200.00 [%]
Calculated: -
Scaling: PERCENT
Unit selection: p0595
Max
200.00 [%]
Parameters
List of parameters
0 signal
No
No
No
No
No
Data type: U32 / Binary
Dyn. index: CDS, p0170
Func. diagram: 7958
Factory setting
0
Data type: FloatingPoint32
Dyn. index: DDS, p0180
Func. diagram: 7950
Factory setting
10.00 [%]
Data type: FloatingPoint32
Dyn. index: DDS, p0180
Func. diagram: 7950
Factory setting
20.00 [%]
FP
8010
8010
8011
8011
8012
1-297