Siemens SINAMICS G120D List Manual page 371

r3113.0...15 CO/BO: NAMUR message bit bar / NAMUR bit bar
Access level: 3
Can be changed: -
Units group: -
Min
-
Description: Displays the status of NAMUR signal bit bar.
The faults or alarms are assigned to the appropriate signaling/message classes and influence a specific message
bit.
Bit field: Bit Signal name
00 Fault converter information electron-
ics/SW_error
01 Network fault
02 DC link overvoltage
03 Fault drive converter power electronics
04 Drive converter overtemperature
05 Ground fault
06 Motor overload
07 Bus error
08 External safety-relevant shutdown
10 Error communication internal
11 Fault infeed
15 Other faults
p3117 Change safety message type / Ch. SI mess type
Access level: 3
Can be changed: C(1)
Units group: -
Min
0
Description: Sets the re-parameterization of all safety messages for faults and alarms.
The relevant message type during changeover is selected by the firmware.
0: Safety messages are not re-parameterized
1: Safety messages are re-parameterized
Note: A change only becomes effective after a POWER ON.
r3131 CO: Actual flt value / Actual flt value
Access level: 3
Can be changed: -
Units group: -
Min
-
Description: Displays the fault value of the oldest active fault.
Dependency: Refer to: r2131, r3132
© Siemens AG 2012 - 2013 All Rights Reserved
SINAMICS G120D List Manual (LH14), 01/2013
Calculated: -
Scaling: -
Unit selection: -
Max
-
1 signal
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Calculated: -
Scaling: -
Unit selection: -
Max
1
Calculated: -
Scaling: -
Unit selection: -
Max
-
Parameters
List of parameters
Data type: Unsigned16
Dyn. index: -
Func. diagram: -
Factory setting
-
0 signal
No
No
No
No
No
No
No
No
No
No
No
No
Data type: Unsigned32
Dyn. index: -
Func. diagram: -
Factory setting
0
Data type: Integer32
Dyn. index: -
Func. diagram: 8060
Factory setting
-
FP
-
-
-
-
-
-
-
-
-
-
-
-
1-371