Siemens SINAMICS G120D List Manual page 14

Parameters
Overview of parameters
• U
• T
Scaling
Specification of the reference variable with which a signal value is automatically
converted for a BICO interconnection.
The following reference variables are available:
• p2000 ... p2006: Reference speed, reference voltage, etc.
• PERCENT: 1.0 = 100 %
• 4000H: 4000 hex = 100 %
Dyn. index (dynamic index)
For parameters with a dynamic index [0...n], the following information is specified
here:
• Data set (if available).
• Parameter for the number of indices (n = number - 1).
The following information can be contained in this field:
• "CDS, p0170" (Command Data Set, CDS count)
Example:
p1070[0]  main setpoint [command data set 0]
p1070[1]  main setpoint [command data set 1], etc.
• "DDS, p0180" (Drive Data Set, DDS count)
• "EDS, p0140" (Encoder Data Set, EDS count)
• "MDS, p0130" (Motor Data Set, MDS count)
• "PDS, p0120" (Power unit Data Set, PDS count)
Data sets can only be created and deleted when p0010 = 15.
Note:
Information on the data sets can be taken from the following references:
• Operating Instructions SINAMICS G120D Frequency Converter with
CU240D-2 Control Units.
• Operating Instructions SINAMICS G120D Frequency Converter with
CU250D-2 Control Units.
1-14
Operation
Pulses are enabled.
Ready
The pulses are not enabled and the status "C(x)" is not active.
U: Run
T: Ready to run
© Siemens AG 2012 - 2013 All Rights Reserved
SINAMICS G120D List Manual (LH14), 01/2013