Siemens SINAMICS G120D List Manual page 396

Parameters
List of parameters
0514 hex: G110M
0515 hex: G120 CU250S-2 Servo
p8920[0...239] PN Name of Station / PN Name Stat
CU240D-2_PN Access level: 3
CU240D-2_PN_F
Can be changed: U, T
CU250D-2_PN_F
Units group: -
Min
-
Description: Sets the station name for the onboard PROFINET interface on the Control Unit.
The active station name is displayed in r8930.
Note: An ASCII table (excerpt) can be found, for example, in the appendix to the List Manual.
The interface configuration (p8920 and following) is activated with p8925 = 1.
The parameter is not influenced by setting the factory setting.
PN: PROFINET
p8921[0...3] PN IP address of station / PN IP of stat
CU240D-2_PN Access level: 3
CU240D-2_PN_F
Can be changed: U, T
CU250D-2_PN_F
Units group: -
Min
0
Description: Sets the IP address for the onboard PROFINET interface on the Control Unit.
The active IP address is displayed in r8931.
Note: The interface configuration (p8920 and following) is activated with p8925 = 1.
The parameter is not influenced by setting the factory setting.
p8922[0...3] PN Default Gateway of Station / PN Def Gateway
CU240D-2_PN Access level: 3
CU240D-2_PN_F
Can be changed: U, T
CU250D-2_PN_F
Units group: -
Min
0
Description: Sets the default gateway for the onboard PROFINET interface on the Control Unit.
The active default gateway is displayed in r8932.
Note: The interface configuration (p8920 and following) is activated with p8925 = 1.
The parameter is not influenced by setting the factory setting.
p8923[0...3] PN Subnet Mask of Station / PN Subnet Mask
CU240D-2_PN Access level: 3
CU240D-2_PN_F
Can be changed: U, T
CU250D-2_PN_F
Units group: -
Min
0
Description: Sets the subnet mask for the onboard PROFINET interface on the Control Unit.
The active subnet mask is displayed in r8933.
Note: The interface configuration (p8920 and following) is activated with p8925 = 1.
The parameter is not influenced by setting the factory setting.
1-396
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
255
Calculated: -
Scaling: -
Unit selection: -
Max
255
Calculated: -
Scaling: -
Unit selection: -
Max
255
© Siemens AG 2012 - 2013 All Rights Reserved
SINAMICS G120D List Manual (LH14), 01/2013
Data type: Unsigned8
Dyn. index: -
Func. diagram: -
Factory setting
-
Data type: Unsigned8
Dyn. index: -
Func. diagram: -
Factory setting
0
Data type: Unsigned8
Dyn. index: -
Func. diagram: -
Factory setting
0
Data type: Unsigned8
Dyn. index: -
Func. diagram: -
Factory setting
0