Siemens SINAMICS G120D List Manual page 304

Parameters
List of parameters
p2235[0...n] BI: Technology controller motorized potentiometer raise setpoint / Tec_ctrl mop raise
CU240D-2_DP Access level: 3
CU240D-2_DP_F
Can be changed: T
CU240D-2_PN
Units group: -
CU240D-2_PN_F
Min
-
Description: Sets the signal source to continually increase the setpoint for the motorized potentiometer of the technology control-
ler.
The setpoint change (CO: r2250) depends on the set ramp-up time (p2247) and the duration of the signal that is
present (BI: p2235).
Dependency: Refer to: p2236
p2236[0...n] BI: Technology controller motorized potentiometer lower setpoint /
Tec_ctrl mop lower
CU240D-2_DP Access level: 3
CU240D-2_DP_F
Can be changed: T
CU240D-2_PN
Units group: -
CU240D-2_PN_F
Min
-
Description: Sets the signal source to continually reduce the setpoint for the motorized potentiometer of the technology control-
ler.
The setpoint change (CO: r2250) depends on the set ramp-down time (p2248) and the duration of the signal that is
present (BI: p2236).
Dependency: Refer to: p2235
p2237[0...n] Technology controller motorized potentiometer maximum value / Tec_ctrl mop max
CU240D-2_DP Access level: 3
CU240D-2_DP_F
Can be changed: U, T
CU240D-2_PN
Units group: 9_1
CU240D-2_PN_F
Min
-200.00 [%]
Description: Sets the maximum value for the motorized potentiometer of the technology controller.
Dependency: Refer to: p2238
p2238[0...n] Technology controller motorized potentiometer minimum value / Tec_ctrl mop min
CU240D-2_DP Access level: 2
CU240D-2_DP_F
Can be changed: U, T
CU240D-2_PN
Units group: 9_1
CU240D-2_PN_F
Min
-200.00 [%]
Description: Sets the minimum value for the motorized potentiometer of the technology controller.
Dependency: Refer to: p2237
1-304
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: p0595
Max
200.00 [%]
Calculated: -
Scaling: -
Unit selection: p0595
Max
200.00 [%]
© Siemens AG 2012 - 2013 All Rights Reserved
SINAMICS G120D List Manual (LH14), 01/2013
Data type: U32 / Binary
Dyn. index: CDS, p0170
Func. diagram: 7954
Factory setting
0
Data type: U32 / Binary
Dyn. index: CDS, p0170
Func. diagram: 7954
Factory setting
0
Data type: FloatingPoint32
Dyn. index: DDS, p0180
Func. diagram: 7954
Factory setting
100.00 [%]
Data type: FloatingPoint32
Dyn. index: DDS, p0180
Func. diagram: 7954
Factory setting
-100.00 [%]