Siemens SINAMICS G120D List Manual page 4

Safety notices
This Manual contains information which you must observe to ensure your own personal safety as well as
to avoid material damage. The notices referring to your personal safety are highlighted in the manual by
a warning triangle; notices that relate to material damage only have no warning triangle. The notices
shown below are graded according to the level of danger (from most to least hazardous):
Danger
Indicates that death or serious injury will result if proper precautions are not taken.
Warning
Indicates that death or serious injury may result if proper precautions are not taken.
Caution
With a warning triangle, indicates that minor injury may result if proper precautions are not taken.
Caution
Without a warning triangle, indicates that material damage may result if proper precautions are not taken.
Notice
Indicates that an undesirable result or state may occur if the corresponding instructions are not observed.
If more than one level of danger is simultaneously applicable, the warning notice for the highest level is
used. A warning on a warning triangle indicating possible personal injury may also include a warning relat-
ing to material damage.
Qualified personnel
The associated device/system may only be installed and operated in conjunction with this documentation.
The equipment/system may only be commissioned and operated by qualified personnel. For the pur-
pose of the safety information in this documentation, a "qualified person" is someone who is authorized to
energize, ground, and tag equipment, systems, and circuits in accordance with established safety proce-
dures.
Proper Use of Siemens Products
Note the following:
Warning
Siemens products are only permitted to be used for the applications specified in the catalog and in the
associated technical documentation. If third-party products and components are to be used, they must be
recommended or approved by Siemens. To ensure proper and safe operation of these products, they must
be correctly transported, stored, set up, mounted, installed, commissioned, operated, and maintained. The
permissible environmental conditions must be maintained. Information in the associated documentation
must be observed.
Trademarks
All names identified with ® are registered trademarks of Siemens AG. Any other names used in this pub-
lication may be trademarks whose use by third parties for their own purposes could violate the rights of
the owner.
Copyright Siemens AG 2012 - 2013 All Rights Reserved
The reproduction, transmission, or use of this document or its con-
tents is not permitted without express written permission. Offenders
will be liable for damages. All rights reserved, especially those relating
to granting patents or GM registration.
Siemens AG
Industry Sector
Postfach 4848
90327 NUREMBERG
GERMANY
Siemens Aktiengesellschaft
Liability Disclaimer
We have checked that the contents of this document correspond to
the hardware and software described. Nevertheless, we cannot as-
sume responsibility for any deviations that may arise. The data in this
document is regularly checked and any necessary corrections includ-
ed in subsequent editions.
© Siemens AG 2012 - 2013
Subject to change without prior notice.
SINAMICS G120D List Manual (LH14)