Command Interface - Standard Commands; Read Array Command - Analog Devices ADSP-BF506F Hardware Reference Manual

Table 6-4. Command Codes (Cont'd)
Hex Code
0x40
0x50
0x60
0x70
0x90
0x98
0xB0
0xC0
0xD0
0xFF
Command Interface – Standard Commands
The following commands are the basic commands used to read, write to,
and configure the device. Refer to
with the following descriptions in this section.

Read Array Command

The read array command returns the addressed bank to read array mode.
One bus write cycle is required to issue the read array command and
return the addressed bank to read array mode. Subsequent read operations
read the addressed location and output the data. A read array command
can be issued in one bank while programming or erasing in another bank.
However, if a read array command is issued to a bank currently executing
a program or erase operation the command is executed but the output
data is not guaranteed.
ADSP-BF50x Blackfin Processor Hardware Reference
Command
Program Setup
Clear Status Register
Block Lock Setup, Block Unlock Setup, Block Lock Down Setup and Set
Configuration Register Setup
Read Status Register
Read Electronic Signature
Read CFI Query
Program/Erase Suspend
Protection Register Program
Program/Erase Resume, Block Erase Confirm or Block Unlock Confirm
Read Array
Internal Flash Memory
Table 6-5 on page 6-16 in conjunction
6-7