Manual Contents
•
Chapter 17, "CAN Module"
Describes the CAN module, a low bit rate serial interface intended
for use in applications where bit rates are typically up to 1Mbit/s.
•
Chapter 18, "SPI-Compatible Port Controller"
Describes the Serial Peripheral Interface (SPI) port that provides an
I/O interface to a variety of SPI compatible peripheral devices.
•
Chapter 19, "SPORT Controller"
Describes the independent, synchronous Serial Port Controller
which provides an I/O interface to a variety of serial peripheral
devices.
•
Chapter 20, "Parallel Peripheral Interface"
Describes the Parallel Peripheral Interface (PPI) of the processor.
The PPI is a half-duplex, bidirectional port accommodating up to
16 bits of data and is used for digital video and data converter
applications.
•
Chapter 21, "Removable Storage Interface"
Describes the RSI interface for multimedia cards (MMC), secure
digital memory cards (SD), secure digital input/output cards
(SDIO) and consumer electronic ATA devices (CE-ATA).
•
Chapter 22, "ADC Control Module (ACM)"
Describes the ADC control module (ACM), which provides an
interface to synchronize the controls between the processor and the
internal analog-to-digital converter (ADC) module.
•
Chapter 23, "Analog/Digital Converter (ADC)"
Describes the internal ADC, which is a dual, 12-bit, high speed,
low power, successive approximation ADC that operates from a
single 2.7 V to 5.25 V power supply and features throughput rates
up to 1.66 MSPS. The device contains two ADCs, each preceded
by a 3-channel multiplexer, and a low noise, wide bandwidth
track-and-hold amplifier that can handle input frequencies in
excess of 30 MHz.
liv
ADSP-BF50x Blackfin Processor Hardware Reference
Need help?
Do you have a question about the ADSP-BF506F and is the answer not in the manual?