Analog Devices ADSP-BF506F Hardware Reference Manual page 53

• Chapter 9, "General-Purpose Ports"
Describes the general-purpose I/O ports, including the structure of
each port, multiplexing, configuring the pins, and generating
interrupts.
• Chapter 10, "General-Purpose Timers"
Describes the eight general-purpose timers.
• Chapter 11, "Core Timer"
Describes the core timer.
• Chapter 12, "Watchdog Timer"
Describes the watchdog timer.
• Chapter 13, "General-Purpose Counter"
Describes the Rotary (up/down) Counter. This counter provides
support for manually controlled rotary controllers, such as the vol-
ume wheel on a radio device. This unit also supports industrial or
motor-control type of wheels.
• Chapter 14, "PWM Controller"
Describes the The PWM controller—a flexible, programmable,
three-phase PWM waveform generator that can be programmed to
generate the required switching patterns to drive a three-phase volt-
age source inverter for ac induction motor (ACIM) or permanent
magnet synchronous motor (PMSM) control.
• Chapter 15, "UART Port Controllers"
Describes the Universal Asynchronous Receiver/Transmitter port
that converts data between serial and parallel formats. The UART
supports the half-duplex IrDA® SIR protocol as a mode-enabled
feature.
• Chapter 16, "Two-Wire Interface Controller"
Describes the Two-Wire Interface (TWI) controller, which allows
a device to interface to an Inter IC bus as specified by the Philips
2
C Bus Specification version 2.1 dated January 2000.
I
ADSP-BF50x Blackfin Processor Hardware Reference
Preface
liii