Display Ipv6 Neighbors Count - H3C s3100 series Command Manual

You can use the reset ipv6 neighbors command to clear specific IPv6 neighbor information.
Related commands: ipv6 neighbor, reset ipv6 neighbors.
Examples
# View all neighbor information.
<Sysname> display ipv6 neighbors all
IPv6 Address
2008::110
FE80::215:E9FF:FEAC:69B6
FE80::20F:E2FF:FE00:2201
2008::3610
Table 1-9 Description on the fields of the display ipv6 neighbors command
Field
IPv6 Address
Link-layer
VID
Interface
State
T
Age

display ipv6 neighbors count

Syntax
display ipv6 neighbors { all | dynamic | static | interface interface-type interface-number | vlan
vlan-id } count
View
Any view
Type: S-Static D-Dynamic
Link-layer
0015-e9ac-69b6 1
0015-e9ac-69b6 1
000f-e200-2201 1
000f-e200-2201 1
IPv6 address of a neighbor
Link layer address (MAC address of a neighbor)
ID of the VLAN to which the interface connected to a neighbor belongs
Interface connected to a neighbor
State of a neighbor, which can be:
INCMP: Address resolution is in progress, so the link layer address of
the neighbor is unknown yet.
REACH: The neighbor is reachable.
STALE: The reachability to the neighbor is unknown. The device
does not verify the reachability to the neighbor unless it sends a
packet to the neighbor.
DELAY: The reachability to the neighbor is unknown. The device will
send a neighbor request message after a delay time.
PROBE: The reachability to the neighbor is unknown. The device
sent a neighbor request message to verify the reachability.
Type of neighbor information, including S (static configuration) and D
(dynamic acquisition).
For a static entry, "-" is displayed.
For a dynamic entry, the time (in seconds) since it is reachable last
time is displayed, and if it is never reachable, "#" is displayed (for a
dynamic neighbor only).
VID Interface
GE1/1/2
GE1/1/2
GE1/1/2
GE1/1/2
Description
1-13
State T Age
REACH S -
STALE D 22
STALE D 28
STALE D 28