Distributed-Gateway Local; Gateway Subnet - H3C CR16000-F Command Reference Manual

Field
Cause
Related commands
reset counters interface vsi-interface

distributed-gateway local

Use distributed-gateway local to specify a VSI interface as a distributed gateway to
provide services for the local site.
Use undo distributed-gateway local to restore the default.
Syntax
distributed-gateway local
undo distributed-gateway local
Default
A VSI interface is not a distributed gateway.
Views
VSI interface view
Predefined user roles
network-admin
Usage guidelines
If a VXLAN uses distributed gateway services, you must assign the same IP address to the VXLAN's
VSI interfaces on different VTEPs. To avoid IP address conflicts, you must specify the VSI interface
on each VTEP as a distributed gateway.
Examples
# Specify VSI-interface 100 as a distributed gateway.
<Sysname> system-view
[Sysname] interface vsi-interface 100
[Sysname-Vsi-interface100] distributed-gateway local

gateway subnet

Use gateway subnet to assign a subnet to a VSI.
Use undo gateway subnet to remove a subnet from a VSI.
Syntax
gateway
prefix-length }
undo gateway
prefix-length }
Description
Cause for the physical link state of an interface to be DOWN:
•
•
subnet { ipv4-address
subnet {
Administratively—The interface has been manually shut down by
using the shutdown command. To restore the physical state of the
undo shutdown
interface, use the
Not connected—The interface is not mapped to any VSI, or the
mapped VSI does not have any AC or PW.
wildcard-mask
ipv4-address wildcard-mask
41
command.
| ipv6-address
| ipv6-address