Controller T3; Crc - H3C SR6600 Command Reference Manual

controller t3

Syntax
controller t3 interface-number
View
System view
Default Level
2: System level
Parameters
interface-number: CT3 interface number.
Description
Use the controller t3 command to enter CT3 interface view.
Related command: display controller t3.
Examples
# Enter the view of interface T3 2/0/0.
<Sysname> system-view
[Sysname] controller t3 2/0/0
[Sysname-T3 2/0/0]

crc

Syntax
crc { 16 | 32 | none }
undo crc
View
Synchronous serial interface view
Default Level
2: System level
Parameters
16: Uses 16-bit CRC.
32: Uses 32-bit CRC.
none: Uses no CRC.
Description
Use the crc command to configure CRC mode for the serial interface formed on CT3 interfaces.
Use the undo crc command to restore the default, that is, 16-bit CRC.
Related command: t1 channel-set, t1 unframed, and using.
Examples
# Apply 32-bit CRC to a serial interface formed on interface T3 2/0/0 in unchannelized mode.
<Sysname> system-view
[Sysname] controller t3 2/0/0
[Sysname-T3 2/0/0] using t3
3-90