Installing Service Modules - H3C S12500R Series Installation, Quick Start

Figure 3-2 Installing an MPU (S12504R)
(1) Loosen the captive screws and remove the filler panel
(2) Pivot up the handle
(3) Push the MPU into the slot along the guide rails
(4) Push the MPU until the handle makes close contact with the slot edges
(5) Push the handle until the MPU is secure in position
(6) Fasten the screws on the MPU

Installing service modules

CAUTION:
• To prevent a filler panel from being drawn into the chassis when the fan speed is high, use both
hands to grasp the filler panel by its two sides during filler panel installation and removal on an
operating device.
• To avoid module damage or operation failure, use Type H service modules only with Type H
fabric modules. Type H service modules have a character of H in their module identifiers
(LSXM1CGQ36HBR1 for example). Type H fabric modules have a character string of SFH in
their module identifiers (LSXM2SFH16CR1 for example).
1
3-3
3
2
6
5
4