Service Aggregation Platform Modules; Sap-48Gbe - H3C SR6616 Manual

Service aggregation platform modules

IMPORTANT:
Use transceiver modules for the service aggregation platform modules (SAPs) provided by H3C
only. The router might be incompatible with transceiver modules from other vendors. The system
generates an alarm when a transceiver module from another vendor is installed.
Each combo interface on the SAPs has a fiber port and a copper port. Only one port is activated at a
time. By default, the fiber port is activated. To activate a port, use the
command in interface view. For more information about the
fiber }
command, see H3C SR6600/SR6600-X Routers Interface Command Reference(V7).
fiber }
A SAP module provides network ports for receiving packets from the network and sending packets to
the network. This section describes the SAPs available for the H3C SR6616 router.

SAP-48GBE

The SAP-48GBE has 48 high-performance RJ-45 ports that can be both routed and switched. One
two-color LED is available for each port to indicate their activity and link status. The module also has
a RUN LED to indicate the module operating status.
Front panel
Figure2-23 SAP-48GBE front panel
4
5
(1) LEDs for GE ports 0 to 47
(3) GE ports 0 to 47
(5) Captive screw
Technical specifications
Item
Flash
Memory type and size
NVRAM
Max power consumption
Connector type
Number of interfaces
Interface standards
Interface type
Cable type
1
3
(2) SAP module status LED (RUN)
(4) Ejector levers
Specification
4 MB
•
Default—Two 1-GB DDR2 SDRAMs
•
Maximum—Two 2-GB DDR2 SDRAMs
128 KB
200 W
RJ-45
48
802.3, 802.3u, and 802.3ab
Automatic MDI/MDIX
Straight-through/crossover Ethernet cable
2-27
combo enable { copper |
combo enable { copper |
2