Enabling The Ntp Service; Configuring Ntp Association Modes; Configuring Ntp In Client/Server Mode - H3C SR6600-X Configuration Manual

Tasks at a glance
(Optional.)
(Optional.)

Enabling the NTP service

Step
1. Enter system view.
2. Enable the NTP service.

Configuring NTP association modes

This section describes how to configure NTP association modes.

Configuring NTP in client/server mode

When the device operates in client/server mode, specify the IP address for the server on the client.
Follow these guidelines when you configure an NTP client:
• A server must be synchronized by other devices or use its local clock as a reference source before
synchronizing an NTP client. Otherwise, the client will not be synchronized to the NTP server.
If the stratum level of a server is higher than or equal to a client, the client will not synchronize to that
•
server.
• You can configure multiple servers by repeating the ntp-service unicast-server and ntp-service ipv6
unicast-server commands.
To configure an NTP client:
Step
1. Enter system view.
Configuring NTP authentication
Configuring NTP optional parameters
Command
system-view
ntp-service enable
Command
system-view
72
Remarks
N/A
By default, the NTP service is not
enabled.
Remarks
N/A