Ntp-Service In-Interface Disable - H3C SR6600 Command Reference Manual

Use undo ntp-service broadcast-server to remove the configuration.
Syntax
ntp-service broadcast-server [ authentication-keyid keyid | version number ] *
undo ntp-service broadcast-server
Default
The device does not operate in any NTP operation mode.
Views
Interface view
Default command level
3: Manage level
Parameters
authentication-keyid keyid: Specifies the key ID to be used for sending broadcast messages to broadcast
clients, where keyid is in the range of 1 to 4294967295. This parameter is not meaningful if
authentication is not required.
version number: Specifies the NTP version. The value range for the number argument is 1 to 4, and the
default is 3.
Examples
# Configure the device to operate in broadcast server mode and send NTP broadcast messages on
GigabitEthernet 2/0/1, using key 4 for encryption, and set the NTP version to 3.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] ntp-service broadcast-server authentication-keyid 4
version 3

ntp-service in-interface disable

Use ntp-service in-interface disable to disable an interface from receiving NTP messages.
Use undo ntp-service in-interface disable to restore the default.
Syntax
ntp-service in-interface disable
undo ntp-service in-interface disable
Default
All interfaces are enabled to receive NTP messages.
Views
Interface view
Default command level
3: Manage level
Examples
# Disable interface GigabitEthernet 2/0/1 from receiving NTP messages.
<Sysname> system-view
79