Connecting An E1/T1 Cable; E1/T1 Cable Overview - H3C SR6604 Installation Manual

Identify the Rx and Tx ports. Plug the LC connector at one end of one fiber cable into the Rx port
3.
of the router and the LC connector at the other end into the Tx port of the peer device. Plug the
LC connector at one end of another fiber cable into the Tx port of the router and the LC
connector at the other end to the Rx port of the peer device.
Figure 50 Installing the fiber connector
View the LINK LED after connection.
4.
If the LED is on, the optical fiber link is present.
If the LED is off, no link is present. This might be because the TX and Rx port of the optical
fiber are not connected correctly. In this case, connect the optical fiber again.

Connecting an E1/T1 cable

CAUTION:
When connecting the interface cable, pay attention to the mark on the interface to avoid wrong
insertion, which might damage the interface module or even the router.
As a best practice, install a lightning protector at the input end of the 8T1 cables to protect them
against lightning strikes more efficiently when they are led outdoors.

E1/T1 cable overview

E1 cable
You can use an 8E1 interface cable to connect to MIM-8E1(75)/MIM-8E1(75)-F modules.
43