Connecting An E1/T1 Cable; E1/T1 Cable Overview - H3C SR6604 Installation Manual

For interface modules with dust plugs provided as accessories, install dust plugs for empty fiber
ports in time.
3. Pull the bail latch on the transceiver module upwards.
4. Take the transceiver module by its two sides and push the end without the bail latch gently into
the port until it is firmly seated in the fiber port.
5. Remove the dust plug and dust cap from the transceiver module and fiber connector,
respectively.
6. Orient the MPO fiber connector with the white dot on it facing right. Insert the connector
horizontally into the transceiver module, and then push it into the transceiver module slightly
until it clicks into the place, as shown in Figure4-14.
7. Use cable ties to bind the fiber cable every 150 mm (5.91 in).
8. Attach labels to the fiber cable as required.
Figure4-14 Installing a transceiver module and optical fiber (MPO connector)

Connecting an E1/T1 cable

CAUTION:
When connecting the interface cable, pay attention to the mark on the interface to avoid wrong
insertion, which might damage the interface module or even the router.
As a best practice, install a lightning protector at the input end of the 8T1 cables to protect them
against lightning strikes more efficiently when they are led outdoors.

E1/T1 cable overview

E1 cable
You can use an 8E1 interface cable to connect to MIM-8E1(75)/MIM-8E1(75)-F modules.
1
3
44
2
4