Figure 20 Installing a CFP2 transceiver module
Connecting an E1 cable
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
For more information, see
2.
Connect the HD96 connector of the E1 cable to the interface on the subcard and use a
screwdriver to fasten the screws on the connector.
3.
Connect the other end of the E1 cable to the peer device.
Figure 21 Installing an E1 cable
Installing an SMB coaxial clock cable
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
For more information, see
2.
Remove the dust plug from the target clock port.
3.
Insert the SMB connector of the SMB coaxial clock cable into the clock port.
4.
Connect the other end of the SMB coaxial clock cable to the peer network device.
"Attaching an ESD wrist
1
2
2
"Attaching an ESD wrist
15
strap."
strap."