Table of Contents
Advertisement
Figure 13 Grounding the router through the grounding terminal on the rack
Connecting interface cables
Connect cables to the interfaces on the router before powering on the router.
Connecting an E1 cable
Only RA10-E supports E1 cables.
An E1 cable provides an RJ-45 connector at one end and a pair of BNC connectors at the other end.
To connect an E1 cable:
Connect the RJ-45 connector of the E1 cable to the E1 port on the router.
1.
Connect the Tx connector and the Rx connector of the E1 cable to the Rx connector and the Tx
2.
connector on the peer device, respectively.
13
Advertisement
Table of Contents
