Replacing An E1 Cable - H3C CR16000-M Installation Manual
Hide thumbs
Also See for CR16000-M:
- Installation, quick start (4 pages) ,
- Quick start manual (21 pages)
Table of Contents
Advertisement
Figure8-9 Removing a transceiver module (LC interface)
Figure8-10 Removing a transceiver module (MPO interface)
Replacing an E1 cable
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
For more information, see "Attaching an ESD wrist strap."
2.
Use a screwdriver to loosen the screws on the connector of the E1 cable.
3.
Pull out the E1 cable slowly.
8-7
Advertisement
Chapters
Table of Contents
