Samsung S3C6400X User Manual page 609

CAMERA INTERFACE
IMAGE CAPTURE ENABLE REGISTER
Register Address
CIIMGCPT 0x780000C0
CIIMGCPT
ImgCptEn [31]
ImgCptEn_CoSc [30]
ImgCptEn_PrSc [29]
Reserved [28:26]
Cpt_FrEn_Co [25]
Cpt_FrEn_Pr [24]
Cpt_FrPtr [23:19]
Cpt_ FrMod [18]
Cpt_ FrCnt [17:10]
Reserved [9:0]
Preliminary product information describe products that are in development,
20-44
for which full characterization data and associated errata are not yet available.
Specifications and information herein are subject to change without notice.
R/W
RW
Bit
camera interface global capture enable
capture enable for codec scaler. This bit must be zero in codec
scaler-bypass mode.
capture enable for preview scaler. This bit must be zero in preview
scaler-bypass mode.
Capture codec frame control. (only camera input is applied)
1 : Enable (Step-by-Step frame one shot mode)
0 : Disable (FreeRun mode)
Capture preview frame control. (only camera input is applied)
1 : Enable (Step-by-Step frame one shot mode)
0 : Disable (Free Run mode)
Capture sequence turn-around pointer (Common preview &
codec)
Capture frame control mode (Common preview & codec)
1 : Apply Cpt_FrCnt mode (capture Cpt_FrCnt frames along the
Cpt_FrSeq after capture dma frame control becomes enable. If
Cpt_FrCnt = 0, then no more capture)
0 : Apply Cpt_FrEn mode (capture frames along the Cpt_FrSeq
during Cpt_FrEn is high. This sequence will be repeated until
capture frame control disable)
Wanted number of frames to be captured (Common preview &
codec). When read, you will see the value of a shadow register
which is downcounted when a frame is captured. That is,
Cpt_FrCnt has an initially loaded value still after a frame is
captured.).
Description
Image capture enable command
Description
S3C6400X RISC MICROPROCESSOR
Reset Value
Initial
State
0
M L
0
X O
0
X O
0
O O
0
X X
0
X O
0
X O
0
X X
0
X X
0
X X
0
X X