Inspecting, Signal Lamp (Option) - ABB IRB 6700 Product Manual

3 Maintenance

3.3.14 Inspecting, signal lamp (option)

3.3.14 Inspecting, signal lamp (option)
Location of signal lamp
The signal lamp is located as shown in this figure.
Required equipment
Equipment, etc.
Signal lamp kit
Standard toolkit
Other tools and procedures may
be required. See references to
these procedures in the step-by-
step instructions below.
Inspecting, signal lamp
Use this procedure to inspect the function of the signal lamp.
1
2
3
136
Action
Check that signal lamp is lit when motors are put in
operation ("MOTORS ON").
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot working area.
If the lamp is not lit, trace the fault by:
• Checking whether the signal lamp is broken.
If so, replace it.
• Checking cable connections.
• Checking the cabling. Replace the cabling if a
fault is detected.
© Copyright 2013 ABB. All rights reserved.
Art. no. Note
See Spare parts on To be replaced if damage is detected.
page 565.
- Content is defined in section
ard toolkit on page
These procedures include references
to the tools required.
Note
Art. no. is specified in
equipment on page
Stand-
559.
Required
136.
3HAC044266-001 Revision: -