ABB IRB 6700 Product Manual page 450

4 Repair
4.8.1 Replacing the axis-1 gearbox
Continued
Equipment, etc
O-ring
Sealing ring
Required tools and equipment
Equipment, etc.
Oil collecting vessel
Oil dispenser
Lifting accessory
Removal tool M14
Bits extender
Lifting eye
Lifting eye
Fender washer
Lifting shackle
Roundsling, 1.5 m
Roundsling, 1 m
Lifting accessory (chain)
Lifting eye
Lifting accessory, motor
Removal tool M14
Rotation tool
Aligning tool
24 VDC power supply
Guide pin, M12x200
Guide pin, M12x250
Guide pin, M16x150
Guide pin, M16x200
Leak-down tester
Calibration Pendulum toolkit
Continues on next page
450
Article number
3HAB3772-107
-
Article number
-
-
3HAC044402-001
3HAC047108-001
3HAC12342-1
3HAC16131-1
3HAC16131-1
-
-
-
-
3HAC15556-1
3HAC14457-4
3HAC14459-1
3HAC047108-001
3HAC7887-1
3HAC046645-001
-
3HAC13056-3
3HAC13056-4
3HAC13120-2
3HAC13120-3
3HAC0207-1
3HAC15716-1
© Copyright 2013 ABB. All rights reserved.
Note
D=102x3
Used on motor flange.
Note
The capacity of the vessel must be
sufficient to take the complete amount
of oil.
One example of oil dispenser can be
found in section Type of lubrication in
gearboxes on page 137.
Used to push out the motor, if neces-
sary.
Always use removal tools in pairs.
300 mm, bits 1/2"
M12
M12
Outer diameter: minimum 26 mm, hole
diameter: 13 mm, thickness: 3 mm.
SA-10-8-NA1
Length: 1.5 m. Lifting capacity: 1,000
kg.
Length: 1 m. Lifting capacity: 1,000 kg.
Lifting instruction 3HAC15880-2 en-
closed.
M16
Used to push out the motor, if neces-
sary.
Always use removal tools in pairs.
Used to rotate the motor pinion.
Used for aligning the gearbox against
the frame, so that the play in the motor
does not need to be adjusted.
Used to release the motor brakes.
Always use guide pins in pairs!
Always use guide pins in pairs!
Always use guide pins in pairs!
Always use guide pins in pairs!
3HAC044266-001 Revision: -