Inspecting Signal Lamp (Option) - ABB IRB 2600ID Product Manual

3.3.12 Inspecting Signal lamp (option)

Location of signal lamp
Signal lamp is an option.
Located as shown in the figure.
The figure shows IRB 2600 Standard.
xx0800000290
A
B
C
D
Required equipment
Equipment
Signal lamp
Standard toolkit
Other tools and procedures may be required.
See references to these procedures in the
step-by-step instructions below.
Inspecting signal lamp
Use this procedure to inspect the function of the signal lamp.
1
Product manual - IRB 2600
3HAC035504-001 Revision: AD
Signal lamp
R3.H1 +, R3.H2 -
R2.CP
R2.CS
Note
If the signal lamp is damaged, it shall be replaced!
Action
Check that the signal lamp is lit when motors
are put in operation ("MOTORS ON").
© Copyright 2009-2023 ABB. All rights reserved.
3.3.12 Inspecting Signal lamp (option)
A
B C D
Note
For spare parts no. see Spare parts - Spare
parts options in Product manual, spare
parts - IRB 2600.
Content is defined in section
on page 452.
These procedures include references to the
tools required.
Note
3 Maintenance
Standard tools
Continues on next page
149