Changing Oil, Axis-1 Gearbox; Usage Of Oil Dispenser; Location Of Oil Plugs - ABB IRB 6700 Product Manual

3 Maintenance

3.4.2 Changing oil, axis-1 gearbox

3.4.2 Changing oil, axis-1 gearbox

Usage of oil dispenser

The oil change procedure in this section describes usage of an oil dispenser.

Location of oil plugs

The oil plugs of the gearbox are located as shown in the figure.
xx1200000948
Oil hole with nipple
Used for both draining and filling with an oil
dispenser.
Required material
Material
Lubricating oil
Required tools and equipment
Equipment, etc.
Oil collecting vessel
Oil dispenser
Standard toolkit
Continues on next page
138
Article number
-
-
-
© Copyright 2013 ABB. All rights reserved.
xx1200000950
Vent hole plug
Used for both ventilation and level measure-
ment.
Tightening torque: 24 Nm.
Note
Information about the oil is found in Technical refer-
ence manual - Lubrication in gearboxes.
See Type and amount of oil in gearboxes on page
Note
The capacity of the vessel must be
sufficient to take the complete amount
of oil.
One example of oil dispenser can be
found in section
gearboxes on page
Content is defined in section
toolkit on page
3HAC044266-001 Revision: -
137.
Type of lubrication in
137.
Standard
559.