Boot Revert-Tolerance - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
boot revert-tolerance
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
boot revert-tolerance count time
no boot revert-tolerance
Command introduced before JunosE Release 7.1.0.
Sets the reversion tolerances that the boot logic uses to determine whether the router
should use the normal or backup settings. Issuing this command when high availability
is enabled results in the system cold-restarting the router and using the backup settings
if the tolerance settings are met. The no version restores the default reversion tolerance
settings. The default settings are 3 crashes in 30 minutes.
count—Number of times the operational SRP software crashes; in the range
0–4294967295; default value is 3
time—Time in the range 0–4294967295 seconds in which the set number (count) of
crashes occurs; the default setting is 1800
Global Configuration
Chapter 3: B Commands
303
Advertisement
Table of Contents
