Adding An Infranet Controller Cluster With Imported Cluster Members; Installing And Configuring The Cluster; Adding The Cluster In Nsm - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INFRANET CONTROLLER GUIDE REV 01 Manual

NSM Infranet Controller Configuration Guide
Related
Documentation

Adding an Infranet Controller Cluster with Imported Cluster Members

Installing and Configuring the Cluster

Adding the Cluster in NSM

24
To add an Infranet Controller cluster to NSM, first add the cluster object, and then add
its members. You add cluster members one at a time, in a similar manner to adding
standalone devices.
Once an Infranet Controller cluster is managed by NSM, subsequent changes applied to
the cluster by NSM will be synchronized by the cluster across all cluster members.
Similarly, changes to an Infranet Controller cluster membership that occur through
administrator action on the native device UI will be reflected back to NSM, and NSM will
display the modified cluster after the cluster configuration is imported to NSM.
You can add an Infranet Controller cluster from your existing network into NSM and
import their configurations. Using the Add Device Wizard, you configure a connection
between the management system and the physical device, and then import all device
parameters.
Infranet Controller Services and Device Configurations Supported in NSM on page 5
Adding an Infranet Controller Cluster with Imported Cluster Members on page 24
To add an Infranet Controller cluster to NSM, first add the cluster object, and then add
its members. You add cluster members one at a time, in a similar manner to adding
standalone devices.
Add and import an Infranet Controller cluster in NSM by following these procedures:
Installing and Configuring the Cluster on page 24
1.
Adding the Cluster in NSM on page 24
2.
Adding the Cluster Members in NSM on page 25
3.
Configuring and Enabling the DMI Agent on the Cluster on page 27
4.
5. Importing Cluster Configuration on page 27
You must install and configure the cluster to have logon credentials for an NSM
administrator before you can add the cluster to NSM.
Before you can add an Infranet Controller cluster to NSM, you must first add the cluster
object, and then add its members.
To add a new cluster to NSM:
From the left pane of the NSM UI, click Configure.
1.
Expand Device Manager and select Devices. The Devices workspace appears on the
2.
right side of the screen.
Click the Device Tree tab, click the New button, and select Cluster. The New - Cluster
3.
dialog box appears.
Copyright © 2010, Juniper Networks, Inc.