bgp cluster-id
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
bgp cluster-id { clusterId | ipAddress }
no bgp cluster-id [ clusterId | ipAddress ]
Command introduced before JunosE Release 7.1.0.
Configures a cluster ID if the BGP cluster has more than one route reflector. The no version
causes BGP to use the router ID as the cluster ID.
clusterId—Number in the range 0–4294967295; the cluster ID of this router acting as
a route reflector
ipAddress—Cluster ID of this router acting as a route reflector specified as an IP address
Router Configuration
Chapter 3: B Commands
279