JunosE 11.2.x Command Reference Guide A to M
baseline bridge interface
Syntax
Release Information
Description
Options
Mode
Related Topics
218
baseline bridge interface interfaceType interfaceSpecifier
Command introduced before JunosE Release 7.1.0.
Sets a statistics baseline for a specified network interface belonging to a bridge group
or VPLS instance. The router implements the baseline by reading and storing the statistics
at the time the baseline is set and then subtracting this baseline whenever
baseline-relative statistics are retrieved. There is no no version.
NOTE: Using the baseline bridge interface command for a VPLS instance affects the
specified network interface associated with the VPLS instance, but has no effect on
the VPLS virtual core interface, which represents all of the MPLS tunnels from the router
to the remote VPLS edge (VE) devices. To set a statistics baseline for the VPLS virtual
core interface, use the baseline bridge interface vpls command.
interfaceType—One of the following interface types listed in Interface Types and
Specifiers on page 5
atm
fastEthernet
gigabitEthernet
tenGigabitEthernet
interfaceSpecifier—Particular interface; format varies according to interface type; see
Interface Types and Specifiers on page 5
Privileged Exec
Setting a Baseline for VPLS Statistics in the JunosE BGP and MPLS Configuration Guide
Copyright © 2010, Juniper Networks, Inc.